![]() thus when you lift the lid, the water is escaping and will result in the rice being dryer than optimal. In addition, the steam that is escaping is the water that you put into the rice. So you would need to cook it longer for the top to be cooked while the bottom is being overcooked. If you continue to lift the lid, the temperature would drop, and the top would be less cooked than the bottom. By doing this, you can evenly cook the rice throughout so that the rice isn't too overcooked on the bottom. Then you set it to very low and cover and let it simmer for about 15-20 minute or more depending on quantity. I do recommend stirring it at this point. Typically when you cook rice(once again I am going to assume just plain white rice), you start the water/rice mixture by boiling it on high until it comes to a boil. If you are cooking in a pot, the main reason why you do not want to lift the lid is because you want a even cooking temperature throughout. You need to let it sit for about 5-10 minutes so the steam can continue to cook. However if you are cooking in a rice cooker, the lid should not be immediately lifted off after it says it is done cooking. If you are cooking it in the rice cooker, you wouldn't need to lift the lid to check for done-ness. Information and videos on our products were posted previously in this thread.įeel free to contact us with any questions by email or phone.I am going to assume you are cooking the rice on a pot rather than in rice cooker. ![]() We are still servicing the NSX community with the iLIFT® Intelligent Suspension Lift systems and with our NSX Top Mounts and upgraded urethane bushings for the NSX OEM top mounts. ![]() We recently reduced our website at and eliminated the shopping cart because it was attracting too much of the wrong kind of attention. The iLIFT® Intelligent Suspension Lift systems have created quite a buzz in certain circles of the automotive industry. This patent is significant because, among other things, it awards us the right to exclude others from using sensors to monitor the vehicle's ground clearance to automatically adjust the height of vehicles. I am happy to announce that last month the US Patent and Trademark Office issued another patent on our iLIFT® Intelligent Suspension Lift systems. ![]() I will check on the current cost of the coilovers and send you a PM. We offer discount pricing on coilovers and Swift springs. Swift springs list at $99 per main spring and $79 per helper spring. Coilovers such that use only a stiff main spring on the very light front of the NSX will have limited spring compression and thus limited travel. They improve the travel and performance of the car's suspension and consequently performance and travel of the iLIFT(R) System. We highly recommend the use of helper springs. Note that the WW's come with helper springs as standard equipment. Most of our customers use KWV3's but we can get BC coilovers with Swift Springs if you prefer. This custom system includes installation tools such as a DeWalt Right Angle Drill adapter, set of stubby drill bits, a step drill bit and a drilling template to make installation much easier. The current introductory price of the iLIFT® Front and Rear system with the Custom NSX Fender pre-mounted components is $4,245.
0 Comments
Leave a Reply. |